How do I repeat one section?

Written steps

1. Open your scene.
2. Go to Run Lines or Table Read.
3. Find the line where you want the section to begin.
4. Swipe right on that line.
5. Tap the orange arrow pointing right to set the start point.
6. Find the line where you want the section to end.
7. Swipe right on that line.
8. Tap the orange arrow pointing left to set the end point.
9. Swipe up from the bottom to open the control panel.
10. Tap Loop.
11. Check that Loop is highlighted orange.
12. Press Play.

Linus will now repeat that section until you stop it.

To stop repeating the section

You can stop the repeated section in two ways:

1. Tap Pause to stop playback.
2. Turn Loop off in the control panel if you no longer want the section to repeat.

To return to the full scene

1. Swipe right on either the start or end point.
2. Tap the red reset button.
3. Return to the full scene.

Linus will go back to running the full scene as normal.